CCI Stencil Concrete Paving. The site is prepared and subgraded and the mesh and boxing (form work) is placed as required. Concrete is poured and screeding is carried out to falls. A Fresno or Walking Trowel is used to smoothen the surface for CCI Stencil. Edges are prepared and CCI Stencil Header is put in place. The stencil design in placed using a textured roller. The use of textured roller also opens the surface of the concrete to receive CCI Coloured Hardener A first coat of CCI Coloured hardener is applied using a Fresno or Walking trowel so as to work the hardener into the surface. This is followed by a second coat of hardener. If a second additional colour is required apply randomly and trowel. Once dry the stencil paper is removed starting from the last section which had been placed and moving backwards. The surface is cleaned with a broom or blower and sealed with two coats of CCI Sealer starting with a North to South direction on the first day and followed the day after with an East to West application. For any further technical inquiries, please contact our technical department via email.